Partner Registration

Become an X42 NZ Partner

Partner with X42 Monitoring New Zealand

We're building a nationwide network of Retailers and Installers to bring smart tank monitoring to more New Zealand homes.

As an X42 NZ Partner, you'll purchase X42 products directly from us and have access to partner pricing, local NZ supply and the resources you need to sell and install X42 for your customers.

What happens next?

1. Tell us about your business
Complete the application so we can understand what you do and the customers you work with.
2. We'll get in touch
One of our team will contact you to discuss your business, the opportunity and how X42 could fit into what you already do.
3. Get set up
Once approved, we'll confirm your partner level, pricing and initial stock requirements, then get you set up to order X42 through our NZ supply channel.
4. Start growing with X42
Hold stock, sell to your customers and reorder as you grow.

Building X42 across New Zealand

Whether you're a local installer working with a handful of tanks each month or an established retailer serving customers across the country, we'd like to hear from you.
If you work with tank owners, there could be an opportunity to work together.
 
Remove existing Stormwater Pipe

Remove existing Stormwater Pipe

  • If present, remove the existing stormwater fittings from the overflow of the tank.
  • Remove Elbow piece if connected
  • Check inside the tank the fitting type, elbow or straight, to set fill height later
Setting up T-Piece

Setting up T-Piece

  • Test fit the new 90mm T-Piece
  • Check if an extension piece is needed.
  • If yes, cut the additional required piece to suit.
  • Cut the cable tie of the sensor cable without damaging the cable.
Installation of the sensor

Installation of the sensor

  • Insert the sensor from the top and pull it out of the middle of the T-piece.
  • Gently insert the sensor into the tank, including the excess cable.
  • Apply sealant to joints. Set the T-Piece on top of the stormwater pipe and connect it to the tank.

IMPORTANT: Ensure no sealant is transferred to the metal piece of the sensor


Secure Node

Secure Node

  • Set Node on top of the T-Piece.
  • Secure Node with three screws to the T-Piece utilising the enclosure tabs.


IMPORTANT: Do not pull the sensor back out until sealant has cured

NOTE: When installing over a high-flow outlet, extend the neck at least 150mm to let the water pass